Avaire Forum  

Go Back   Avaire Forum > Public Information > Cutting Tile > floor vent

Thread: floor vent Reply to Thread
Your Username: Click here to log in
Image Verification
Post Icons
You may choose an icon for your message from the following list:

Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-22-2009 08:01 PM
Avaire Archive Author: Journeyman
Date: 4/29/2008 9:32 am EDT
Linda I'm reasonably sure your floor vent is not curved - they never are.

A right-angle grinder with a diamond blade would be the tool-of-choice for a professional installer but this isn't a tool a homeowner doing a one-time tile installation is likely to have available to them.

The floor vent would be easy enough to cut if more than one tile was involved because you can measure and mark your tiles and cut from the edges, your wet saw would do the trick.

IF, the required hole falls inside a tile and you can't cut from the edges you must "plunge-cut" with your saw. You would accurately mark your cut locations then (depending on the type of saw you are using) "carefully plunge" the blade into the tile or "carefully plunge" the tile into the saw blade. Either way will work.

Once you make your top-cuts to the corner marks for accuracy, you can then turn the tile over to complete the cuts into the corners. Cuts on the back of the tile can be slightly "over-cut" if need be to complete a cut.

The more you can cut with the saw, the less likely you are to crack the tile when finally removing the waste.

If this isn't clear to you say so and I'll try to clear it up for you.

If you require curved cuts, then that would be a floor vent cut requirement I have never seen, but it could be done.
06-22-2009 08:00 PM
Avaire Archive Author: Chris
Date: 4/28/2008 10:17 pm EDT
To make any curved or circular cuts an angle grinder with a dry cutting diamond blade designed for cutting porcelain will work well.
06-22-2009 07:59 PM
Avaire Archive
floor vent

Author: linda frey
Date: 4/28/2008 3:53 pm EDT
i am installing a new floor in my laundry room. the only difficult cut i see is the floor vent. can you tell me the best way to make the cut and with what?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 11:15 PM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.

(888) 528-2473 Copyright © 2009 : CoMc, LLC All Rights Reserved. ~ Design by Chip Thompson