View Single Post
  #1  
Old 06-24-2009, 10:09 AM
Avaire Archive Avaire Archive is offline
Archive
 
Join Date: Jun 2009
Posts: 943
Default cutting tile at an angle

Author: Brent
Date: 1/10/2009 1:24 pm EDT
I recently put snap tile down in my spare bath and laudry room. The pattern I used was square to the room easy to do, but had problems cutting straight with the plastic building up and causing it to go off line. These cuts were easily hidden because they went under the base board. Now im laying snap tile in my entryway but its going down in a diagonal patern and im trying to figure out what would be the easiest way to cut these tiles in half from corner to corner. I know i can cover most of the cuts up with the transition cover strips but just would like to get suggestions on what would be big enough and best to cut these tile at an angle.
Reply With Quote