Avaire Forum  
Prev Previous Post   Next Post Next
  #11  
Old 06-22-2009, 08:29 PM
Avaire Archive Avaire Archive is offline
Archive
 
Join Date: Jun 2009
Posts: 943
Default

Author: linda
Date: 5/12/2008 2:19 pm EDT
I installed my floor in the laundry room over the weekend and could not more pleased with the way it turned out.

The only problem that I had was the floor vent. We tried to use the rotozip and it didn't seem to be doing what we wanted. The vent was about 3/4 into the tile and within an inch from one edge. We made our drawing and cut from the closest edge and cut the tile into to pieces with one portion of the vent outline still on the main piece. The final cut was made to get fit the vent hole. I just locked the tabs into the other main pieces and put double back tape on the small piece the make a good fit. When I did my grout I just filled the two seams with grout and put the cover over it and its looks great. Know one would know that we had to cut the tile in half just by looking down at the floor the vent covers almost all the seams.

Thanks again for the information I was able to get off this site it made my job a lot easier.

Thanks again

linda
Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:04 PM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.

(888) 528-2473 Copyright © 2009 : CoMc, LLC All Rights Reserved. ~ Design by Chip Thompson