![]() |
#1
|
|||
|
|||
![]()
Author: o.g. morgan
Date: 8/2/2008 6:38 pm EDT do you install the avaire tiles under the toilet or cut the tiles around the toilet? if you place the toilet on the tiles , what do you cut out the toilet drain hole with and how much pressure to apply to tightening the toilet down? |
#2
|
|||
|
|||
![]()
Author: The Avaire Team
Date: 8/3/2008 11:14 am EDT We recommend pulling the toilet and installing the Avaire tile around the flange. Leave at least a 1/4" gap around the flange. Make sure you completely fill the gap between the Avaire tile and the flange with a quality silicon sealer/caulk. You won't want to have the flange in the middle of a tile - thats hard to cut. Better to slit to flange across a couple of tiles. There are several methods for cutting the curved cut. Easiest is using an angle grinder with a diamond blade designed to cut a porcelain tile. Please note - don't try to cut through the entire thickenss of the tile in a single pass. Instead, mark the cut, and then draw the blade across the cut multiple times taking a few 100's each bite. Or, you can make a series of line cuts from the edge to the desired cut line (think a comb). You can then break the individual "teeth". Since the edge of the cut will be hidden under the toilet, it need not be perfect. Make sure to use a wax ring and/or extender that will compensate for the additional height when you replace the toilet (always use a new wax ring). As far as tightness, you want to have the toilet firmly mounted. Of course, over-tightening can break either the toilet rim or the tile. Sorry, but I can't really give you a "pounds" figure. |
#3
|
|||
|
|||
![]()
Author: bud
Date: 10/17/2008 8:18 am EDT once the grout is applied how long shound one wait to put the toliet back in it's place...I do so miss my toliet... |
#4
|
|||
|
|||
![]()
Author: Chris
Date: 10/17/2008 11:36 pm EDT By the time you get this e-mail you can reset your toiet. I set the toilet right after I grout. If you're careful you shouldn't have any problem setting it. |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|